Quote from: Raki1974 on May 11, 2012, 12:26:52 PM
First: Can you explain if its possible to do The things that i want to do with the Obi110?
Yes, it is. The configuration settings I posted were to accomplish your goals.
Quote from: Raki1974 on May 11, 2012, 12:26:52 PM
Second: Is there a more simple way to explain your answer for a newbie to understand?
There's two ways to enter the configuration settings I posted:
A.
OBi Expert Configuration (Introduction)or
B. Directly configure the OBi:
1. Log into the OBi directly at the IP address returned by dialing ***1 (default username/password = admin/admin).
2. Using the navigation tree on the left side of the page, enter the following settings:
System Management -> Auto Provisioning -> ITSP Provisioning -> Method : Disabled
System Management -> Auto Provisioning -> OBiTALK Provisioning -> Method : Disabled
The following will route incoming calls on the LINE Port from CallerID 12341234567 to the Auto Attendant:
Physical Interfaces -> LINE Port -> InboundCallRoute : {12341234567:aa},{ph}
The following will route incoming calls on the SP1 Service from CallerID 12341234567 to the Auto Attendant:
Voice Services -> SP1 Service -> X_InboundCallRoute : {12341234567:aa},{ph}
Click Submit at the bottom of the page before leaving any page you make changes to. Then click Reboot in the upper right corner after all changes have been made to make the changes effective.
You must use method A or method B exclusively to configure the OBi (you cannot alternate between them).