Thanks for the input pc44. In the last few days I've successfully set my obi202 as a router, and it is set up to log in to the PPPoE server, and to provide the DHCP addresses to the rest of my network. My DSL modem is set to bridge. The LAN side of the 202 is then plugged into one of the ports of my LinkSys router, which I have turned off PPPoE. This works fine. I've enabled QoS on the 202 and that gives voice priority over data as I upload large files, like a picture file. All that works fine until about 7AM each morning. (I'm not kidding....). Before 7 everything is still working, then the little red DSL light on my DSL modem starts blinking, and the internet connection goes up and down, and is totally unusable. I've had my provider (at&t) check the DSL line and they say it's okay, I've acquired a new DSL modem, with the same results. "Most" of the rest of the day it all works fine, but I can't just reboot the modem, I have to reboot the 202 to get it all working again, it will not come back on it's own without the reboots. Is there a "keep alive" somewhere that needs to be checked? I've returned it to the original situation with the 202 behind the LinkSys and the LinkSys doing the PPPoE login (which worked fine for several weeks until I tried to do the QoS). The reason I bought the 202 was so I could enable QoS on the outbound voice, where it's sitting now, that would have no effect since the data is closer to the internet than the 202. Thanks for any input.. ...